SET-UP
Connecting The Telephone
1Connect the curly cord to the handset and to the jack on the left side of the telephone.
2Place the handset into the cradle.
3Connect the telephone line cord to the TEL.LINE jack at the rear of the unit.
4Connect the other end into the telephone wall jack. You will hear a click when the modular plug is correctly in place.
Connecting The Power Supply
Plug the AC adapter into the AC Power Jack on the back of your phone, then into a standard electrical outlet or surge protector, if you are using one.
Note: For safety reasons, use only the AC120v DC9v 300mA adapter provided. The adapter is required for the telephone to work correctly.
Hanging The Phone On The Wall
You can place your phone on a flat surface or mount it on a telephone wall plate (not included).
1 To mount using an existing wall plate adapter.*
2 Connect one end of the short phone cord to the telephone wall plate and the other to the telephone
3 Insert the supplied mounting bracket into the slots on the back of the phone and push the bracket up until it clicks. To detach the bracket, simply press the tab and slide down bracket down.
4Insert the two keyhole slots on the phone with the wall plate and slide the phone down, being careful not to pinch the telephone line, until the phone is secure.
5Press and lift out the handset holder. Remove the hanging peg
(located by the switch hook) by pushing it upwards then rotate the peg 180 degrees, then snap it into place so it will hold the handset in place when the phone is mounted on the wall.
*If you do not have an existing wall mount plate adapter they are available at most major electronic and hardware retailers, simply follow the manufacturer’s instructions for installation.
4 – ENGLISH
