ClearSounds V608 manual Answering Machine Operation

Dialing using two-touch Memory Buttons

1 Lift the handset and wait for a dial tone.

2 Press the MEMORY key and memory location (0-9), the stored telephone number will now be dialed.

Flash

The FLASH button can be used to obtain a new dial tone after ending a call. If you subscribe to Call Waiting or three-way calling from your local phone company you can use the FLASH button to switch between calls.

Speakerphone

You can make outgoing or receive incoming calls by speakerphone. Simply press the SPEAKERPHONE button and the sound will be switched to speaker. The Speakerphone LED will light.

You can adjust speaker volume by setting the right side speaker volume control.

To switch between the handset and the

speakerphone.

While on a call using the handset, press the Speaker Button and replace the handset in the cradle.

While on a call using the speakerphone, simply lift the handset.

Headset (headset not included)

You can plug a 2.5mm headset instead of the speakerphone or handset mode.

To make outgoing calls and receive incoming calls, plug the headset to the 2.5mm headset jack (located on the left side of the phone). Press the Speakerphone button to get a dial tone.

Note: When using the headset the call is not amplified

Shaker (Shaker not included)

At the rear of the phone, there is a 3.5mm shaker jack. You can connect an optional shaker device. During ringing, the shaker will

vibrate to alert you.

ANSWERING MACHINE OPERATION

The answering machine has to be turned on in order to receive messages. When a call is received it will be answered after the selected number of rings (see Answering machine set-up).

7 – ENGLISH