Coleman 5040-761 Assembly, Step, Danger, General Safety Information continued, Hex Nut, Edge Pins

General Safety Information continued.

DANGER

•CARBON MONOXIDE HAZARD

•This heater is a combustion appliance. All combustion appliances produce carbon monoxide (CO) during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of CO if used and maintained in accordance with all warn- ings and instructions. Do not block air flow into or out of the heater.

•Carbon Monoxide (CO) poisoning produces flu-like symptoms, watery eyes, headaches, dizziness, fatigue and possibly death. You can't see it and you can't smell it. It's an invisible killer. If these symp- toms are present during operation of this product get fresh air imme- diately!

•For outdoor use only.

•Never use inside house, or other unventilated or enclosed areas. This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life.

WARNING

•This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a ”rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone.

•Propane gas is heavier than air and leaking propane will sink to the lowest level possible. It can ignite by ignition sources including match- es, lighters, sparks or open flames of any kind many feet away from the original leak. Use only propane gas set up for vapor withdraw.

•Propane gas should be stored or used in compliance with local ordi- nances and codes or with ANSI/NFPA 58. Turn off propane when not in use.

CALIFORNIA PROPOSITION 65:

WARNING: Propane and by-products of combustion of propane contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.

Assembly

■Remove all components from package.

				Table not
				included
				on all
				models.
				12 Req’d
				Acorn
				Nuts
			3 Req’d	12 Req’d
			Hex Nut
3 Req’d		3 Req’d		Washers
Flat Head Screw		Edge Pins
15 Req’d		6 Req’d	4 Req’d	3 Req’d
Large Screw	Small Screw		Hex Head Screw Reflector Bolt

DANGER

•EXPLOSION - FIRE HAZARD

•Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49°C).

•Propane is heavier than air and can accumulate in low places. If you smell gas, leave the area immediately.

•Never install or remove propane tank while heater is lighted, near flame, pilot lights, other ignition sources or while heater is hot to touch.

•This heater is red hot during use and can ignite flammables too close to the burner. Keep flammables at least 3 feet from sides & 2 feet from top. Keep gasoline and other flammable liquids and vapors well away from heater.

•The propane tank must always be stored outdoors in a well ventilated space. Never store propane tank in an enclosed area (house, garage, etc.). If heater is to be stored indoors, disconnect the propane tank for outdoor storage.

WARNING

•BURN HAZARD

•Never leave heater unattended when hot or in use.

•Keep out of reach of children.

CAUTION

•SERVICE SAFETY

•Keep all connections and fittings clean. Make sure propane tank valve out- let is clean.

•Inspect hose before use. Replace if there is evidence of abrasion or wear.

•During set up, check all connections and fittings for leaks using soapy water. Never use a flame.

•Use as a heating appliance only. Never alter in any way or use with any device or part not expressly approved by Coleman.

•Check entire hose at least annually.

Tools Required

Phillips screwdriver and 7/16” open-end wrench

Step 1

■ Align 2 Cylinder Cover Pieces.	■ Align holes in Post Base with
Place left piece over right piece as	holes in Cylinder Cover Pieces.
shown.

3