Coleman 5040-761, 5040B747 manual Req’d Brass Reflector Studs

Assembly continued.

Step 12

■ Insert studs into screen cover.

3 Req’d Brass Reflector Studs

Step 13

■Load head assembly by inserting hose into post.

Step 14

■Remove protective film from all reflector pieces prior to assembly.

■Assemble Reflector Assembly

	9 Req’d			3 Req’d		9 Req’d	3 Req’d
Acorn Nut			Flat Head Screw			Washers	Edge Pins
1					2
		Edge Pin
							Upper Stud
■ Install edge pins into the lower					■ Place the other end of the Edge
lip of the reflector panel.					Pin into a second panel of the
					reflector. Place upper hole in sec-
					ond piece over upper stud.
3					4

■ Insert head assembly into post.	■ Attach head assembly to post,
■ Control knob should be above	and loosely install three screws.
decal on post.	■ Tighten screws securely.

■Install the Flat Head Screw into the hole from the bottom of the first two reflector panels.

■After repeating the above steps to assemble the third reflector panel, set the top cap in place and secure with washers and acorn nuts. Make sure all nuts are snug, but DO NOT OVERTIGHTEN.

■Loosely install the Flat Head Screw in place with a washer and Acorn Nut.

5

3 Required

Small Screw

Step 15

3 Req’d	3 Req’d
Acorn Nut	Washers

■Support Heater.

■Locate assembled reflector on 3 studs (ref. Step 12).

■Install washers on studs & securely tighten acorn nuts but do not overtighten! Use a 7/16" nut driver or open-end wrench.

7