Leak Check
WARNING
•Perform all leak tests outdoors.
•Extinguish all open flames.
•NEVER leak test when smoking.
•Do not use the heater until all connections have been leak tested and do not leak.
Hose/Regulator Regulator/Cylinder
ConnectionConnection
•Make
•Apply several drops of solution where hose attaches to regulator.
•Apply several drops of solution where regulator connects to Cylinder.
•Make sure all Patio Heater & Light valves are OFF.
•Turn Cylinder Valve ON.
If bubbles appear at any connection, there is a leak.
•Turn Cylinder Valve OFF.
•If leak is at Hose/Regulator connection: tighten connection and perform another leak test. If you continue to see bubbles after several attempts, contact
•If leak is at Regulator/Cylinder Valve connection: disconnect, reconnect, and perform another leak check. If you continue to see bubbles after sev- eral attempts, cylinder valve is defective and should be returned to cylin- der’s place of purchase.
If NO bubbles appear at any connection, the connections are secure.
•Turn Cylinder Valve OFF.
NOTE: Whenever gas connections are loosened or removed, you must perform a complete leak test.
■ Lift cover while installing |
| ■ Complete installation. |
remaining cylinder cover section. |
|
|
|
|
|
|
|
|
Mantles
■Remove 2 glass panels.
■Slip mantle onto burners. Align clips in mantle with groove in burner. Be sure clip points away from electrode.
Groove
Electrode
■Twist clips.
9
