25
Section 8b - Rear-facing Installation
With Vehicle Seat Belt
WARNING 
DEATH or SERIOUS INJURY can occur
•Not all vehicle seat belts can be used with this car seat. Read vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.
•Vehicle seat belt MUST stay tightly adjusted around car seat at all times. If vehicle seat belt does not stay tight, read the vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.
1Refer to vehicle owner’s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use.
2After selecting a seating location, if adjustable, adjust vehicle seat back into most upright position.
3Rotate car seat on lower base to
4Place car seat
(fig. a)
Rear-facing
Belt Path
5Recline car seat keeping the line inside level indicator in the green striped zone (fig. b). To change recline position, see “Recline Position Adjustment” section.
NOTE: Level indicator is located on the opposite side of car seat and not on the side shown.
6Lift pad off of foot end of car seat to expose
7Open blue belt
the vehicle belt.
Level
Indicator
(fig. b)
Green Striped Zone
Belt Lock-off
Open
To open:
2
1
-Lift locking tab 1 .
-Lift
(fig. c)
8Thread vehicle lap belt or vehicle lap and shoulder belts through belt path and belt
-Thread vehicle seat belt through
-Buckle seat belt and remove any slack in the vehicle seat belt. Be sure vehicle seat belt is not twisted.
1
2
26 | (fig. d) |
|
