33

10Tighten lower anchor belt to secure the car seat. Press down in center of car seat to depress the vehicle cushion and pull free end of lower anchor belt to tighten belt (fig. f).

11Check for secure installation. Gripping car seat at top of armrest, pull car seat front to back and left to right to check for secure installation (fig. g). LATCH belt MUST stay tight.

If LATCH belt does not stay tight or car seat can not be securely installed, try a different LATCH location or use the vehicle’s seat belt to secure the car seat.

12Attach top tether hook (A) to vehicle top tether anchor hardware (B) (fig. h) and pull strap to tighten top tether removing any slack.

If top tether anchor (B) is not available in vehicle, see vehicle owner’s manual or Top Tether Information in “Selecting A Vehicle Seating Location” section.

(fig. f)

(fig. g)

Pull to tighten

(A)

(B) (fig. h)

Removal Of Car Seat Installed With LATCH:

Belt

1 Tip belt adjuster to loosen top tether strapAdjuster (fig. i).

2 Depress retainer spring 1 and unhook 2 tether hook from vehicle top tether anchor (fig. j).

(fig. i)

3Loosen lower anchor belt by depressing belt adjuster slide button and pulling out lower anchor belt.

-Pressing down in center of car seat to reduce tension on lower anchor belt will make it easier to loosen lower anchor belt.

4Remove hook-on connectors.

Tether

Hook

2

Retainer

Spring 1

(fig. j)

-Press and hold the connector retainer spring 1 .

-Push connector in, then rotate connector 2 , and pull out 3 to unhook from the vehicle anchor (fig. k). If the connector can’t be rotated, push in and lift the connector to unhook from the vehicle anchor.

-Repeat to remove hook-on connector on opposite side.

3 2

1

(fig. k)

34

Page 18
Image 18
Combi 8100 instruction manual Fig. g Pull to tighten