BIOS
Virus Warning: During and after the system boots up, any attempt to write to the boot sector or partition table of the hard disk drive will halt the system and an error message will appear.
You should then run an
The default value is Disabled.
Enabled: Activates automatically when the system boots up causing a warning message to appear when anything attempts to access the boot sector.
Disabled: No warning message will appear when anything attempts to access the boot sector.
Note: Many disk diagnostic programs that access the boot sector table can trigger the virus warning message. If you plan to run such a program, we recommend that you first disable the virus warning.
CPU Internal Cache: This controls the status of the processor’s internal cache area. The default is Enabled.
Enabled: This activates the processor’s internal cache thereby increasing performance.
Disabled: This deactivates the processor’s internal cache thereby lowering performance.
Quick Power On Self Test: This category speeds up the Power On Self Test (POST). The default is Enabled.
Enabled: This setting will shorten or skip of the items checked during POST.
Disabled: Normal POST.
Boot Sequence: This category determines which drive is searched first by the O/S (Operating System). The default is A,C,SCSI.
The following is your list of options:
[A, C, SCSI] - [C, A, SCSI] - [C,
Swap Floppy Drive: This will swap your physical drive letters A & B if you are using two floppy disks. The default is Disabled.
Enabled: Floppy A & B will be swapped under the O/S.
Disabled: Floppy A & B will be not swapped.
Page
