Appendix
c)DST This defines the destination location for the operation:
Mode Meaning COPY/
LOAD Destination drive (e.g, 2 for drive two)
DUMP Disk image filename or device,(e.g, g:\images\system2.img)
PCOPY/
PLOAD Destination partition,(e.g, 2:2 indicates the second partition on drive two).
PDUMP Partition image filename (e.g, g:\images\part1.img).
c)SZEy Used to set the size of the destination partitions for either a disk load or disk copy operation.
Available y Options:
FResizes the first partition to maximum size allowed based on file system t type.
LResizes the last partition to maximum size allowed based on file system type.
n=xxxxM | - indicates that the n?h destination partition is to have a size |
| of xxxx Mb. (e.g, SZE2=800M indicates partition two is to |
| have 800 mb.) n=mmP - indicates that the n?h destination |
| partition is to have a size of mm percent of the target disk. |
n=F | - indicates that the n?h destination partition is to remain |
| fixed in size. |
n=V | - Indicates that the partition will be resized according to the |
| following rules: |
| Rule 1 - If the destination disk is larger than the original |
| source disk, then the partition(s) will be expanded to have |
| the maximum amount of space subject to the free space |
| available and the partition type (e.g, FAT16 partitions will |
| have a maximum size of 2048Mb.) |
| Rule 2 - If the destination disk is smaller than the original |
| source disk, (but still large enough to accommodate the |
| data from the source disk), the free space left over after the |
|
|
