4.0 CPI (20 Bars per inch) US POSTNET Bar Code
| Method 2: |
|
Frame Bar & “4”: | {{} | (1 01001) |
Characters “58”: | }}}~{ | (01010 10010) |
Characters “34”: | ~`~{} | (00110 01001) |
Characters “88”: | {}}~{ | (10010 10010) |
Characters “44”: | }~{{} | (01001 01001) |
Characters “79”: | {~`{~ | (10001 11000) |
“9” & Frame Bar: | {{} | (10100 1) |
Text sent to Printer: | SO{{}}}}~{~`~{}{}}~{}~{{}{~`{~{{}SI | |
For both examples, SO = Shift Out (hex 0E), and SI = Shift In (hex 0F).
4.0 CPI (20 Bars per inch) US POSTNET Bar Code
FONT SELECTION
You may select either of the US POSTNET character sets from the front panel, or through escape sequences. (Refer to your User’s Manual for details on front panel menus.)
The following escape sequence will configure the 4.0 cpi POSTNET BAR CODE as a secondary font:
ESC)0K
ESC)0KESC)s4.0H
The sequence above sets the secondary font symbol set to 4.0 cpi POSTNET BAR CODE, and sets the pitch to 4.0 cpi. Once the Secondary character set is configured for 4.0 CPI Postnet Bar Codes, the Shift Out command can be used to activate the bar codes:
Shift Out: | hex 0E |
After the bar code is printed, the normal print mode is activated by using the Shift In command:
Shift In: | hex 0F |
NOTE: It is recommended setting the US POSTNET Bar Code character set as the secondary set, with the normal operation mode as the primary font.
Perform the following steps to determine the check digit for
1.Calculate the check digit:
Add the digits of the postal code: 4+5+8+3+4+8+8+4+4+7+0 = 51
2.Subtract from the next highest multiple of ten:
60 - 51 = 9
The check digit is 9.
Text sent to Printer:
SONUL458348844709SI
SO = Shift Out (hex 0E)
NUL = Nul (hex 00)
SI = Shift In (hex 0F)
55
