Compaq ES40, DS10, DS20E appendix Type b to edit the BSD disklabel

Linux Installation and Configuration Guide for AlphaServer 13

When configuring "Timezones", do not select "Hardware clock set to GMT", nor "Startup through ARC console". Instead select "EST" for the timezone, or the value that is appropriate for your location.

Disk Partitioning

The process of partitioning your boot disk for Linux on your AlphaServer can be somewhat involved. This section provides an example of how perform the partitioning process using fdisk. Note, the partition recommendations used in steps 14-27 are based on a RZ1DD-AA disk geometry. If your disk has a different geometry you will need to use different starting/ending cylinder numbers for each partition. The correct starting/ending cylinder numbers can be computed by using these size recommendations and the number of bytes/cylinder for the disk that you are using (this figure is reported by fdisk). The disk used for this example is a 4.3GB drive (DS-RZ1CF) which fdisk shows as having 1023 cylinders:

4	partitions:
#		size	offset	fstype	[fsize bsize		cpg]
	a:	16368	0	boot	# (Cyl.	1	- 2)
	b:	212784	16368	ext2	# (Cyl.	3	- 28)
	c:	4272048	229152	swap	# (Cyl.	29	- 550)
	d:	3871032	4501200	ext2	# (Cyl.	551	- 1023)

We strongly recommend the following multi-partition layout:

A boot partition – A boot partition is used to reserved the first 2 cylinders (1-2) to write the bootloader in order to boot the disk from SRM.

A root partition – The root partition is where the / (root directory) resides. Always starts at cylinder 3. We recommend creating a root partition of 300Mb minimum and 900Mb maximum.

A swap partition – A swap partition is used to support virtual memory. We commend creating a swap partition of 2 times the computer RAM.

A /usr partition – The /usr partition is where the software of the system resides. This partition should use all of the space left on the hard drive.

To perform the partitioning operation on the disk, when prompted, follow these steps:

1.Arrow to the drive you will be installing the software to and press the ENTER key. You will now be in the fdisk command line

2.Type “m” for help.

3.Type “p” to print the partition table.

4.If there is partition information already configured for the disk, you will need to delete it using the “d” option. Please be sure that you want to zero out this drive. All data will be lost on the drive doing this.

5.Type “b” to edit the BSD disklabel.

6.If you completed the last step correctly, you should see the following: “/tmp/sda contains no disklabel. Do you want to create a disklabel? (y/n)” – Answer Y.

7.Type “m” for more help.

8.Type “p” to print the partition table. You should see a “c” partition that takes up the whole disk. This will have to be removed to install Linux correctly

9.Type “d” to delete a BSD partition

10.Type “c” to delete the c partition

ECG513/0100