Compaq W4000 Diskette Drive Error Messages, Serial Interface Error Messages, Table A-8, Table A-9

Appendix A Error Messages and Codes

A.9 DISKETTE DRIVE ERROR MESSAGES (6xx-xx)

Table A–8.Diskette Drive Error Messages

Table A-8.

Diskette Drive Error Messages

Message	Probable Cause		Message	Probable Cause
6xx-01	Exceeded maximum soft error limit		6xx-20	Failed to get drive type
6xx-02	Exceeded maximum hard error limit		6xx-21	Failed to get change line status
6xx-03	Previously exceeded max soft limit		6xx-22	Failed to clear change line status
6xx-04	Previously exceeded max hard limit		6xx-23	Failed to set drive type in ID media
6xx-05	Failed to reset controller		6xx-24	Failed to read diskette media
6xx-06	Fatal error while reading		6xx-25	Failed to verify diskette media
6xx-07	Fatal error while writing		6xx-26	Failed to read media in speed test
6xx-08	Failed compare of R/W buffers		6xx-27	Failed speed limits
6xx-09	Failed to format a tract		6xx-28	Failed write-protect test
6xx-10	Failed sector wrap test		--	--
600-xx = Diskette drive ID test		609-xx = Diskette drive reset controller test
601-xx = Diskette drive format			610-xx = Diskette drive change line test
602-xx = Diskette read test			611-xx = Pri. diskette drive port addr. conflict
603-xx = Diskette drive R/W compare test			612-xx = Sec. diskette drive port addr. conflict
604-xx = Diskette drive random seek test				694-00 = Pin 34 not cut on 360-KB drive
605-xx = Diskette drive ID media			697-00 = Diskette type error
606-xx = Diskette drive speed test			698-00 = Drive speed not within limits
607-xx = Diskette drive wrap test			699-00 = Drive/media ID error (run Setup)
608-xx = Diskette drive write-protect test

A.10 SERIAL INTERFACE ERROR MESSAGES (11xx-xx)

Table A–9.Serial Interface Error Messages

Table A-9.

Serial Interface Error Messages

Message	Probable Cause	Message	Probable Cause
1101-01	UART DLAB bit failure	1101-13	UART cntrl. signal interrupt failure
1101-02	Line input or UART fault	1101-14	DRVR/RCVR data failure
1101-03	Address line fault	1109-01	Clock register initialization failure
1101-04	Data line fault	1109-02	Clock register rollover failure
1101-05	UART cntrl. signal failure	1109-03	Clock reset failure
1101-06	UART THRE bit failure	1109-04	Input line or clock failure
1101-07	UART Data RDY bit failure	1109-05	Address line fault
1101-08	UART TX/RX buffer failure	1109-06	Data line fault
1101-09	Interrupt circuit failure	1150-xx	Comm port setup error (run Setup)
1101-10	COM1 set to invalid INT	1151-xx	COM1 address conflict
1101-11	COM2 set to invalid INT	1152-xx	COM2 address conflict
1101-12	DRVR/RCVR cntrl. signal failure	1155-xx	COM port address conflict

A-6Compaq Personal Computers

Changed - November 2000