Compatible Systems 1220I manual Saving a Configuration File to Flash ROM, Smds Addressing

Set Dedicated connection Set SMDS connection

Use the Link Configuration: WAN Dialog Box.

Use configure and then set the Mode and ConnectMode keywords in the Link Config WAN 0 (and/or WAN 1) section.

Chapter 6 - Basic Configuration Guide 27

SMDS Configuration

This section covers the settings required for SMDS (Switched Multi-megabit Data Service) operation of the MicroRouter 1220i WAN 0 interface (IP only). SMDS is a connectionless, packet-switched service that offers LAN-to-LAN connectivity across a wide area at up to 1.544 Mbps.

Note: The IP protocol settings and the physical communication vsettings are the same as they would be for Frame Relay operation. The only parameters which should be set differently for SMDS are the Link Configuration and the SMDS addressing section.

Link Configuration

SMDS is presently supported in the MicroRouter only via dedicated line operation.

•

•

CV:

TB:

SMDS Addressing

Many of these parameters will be given to you by your service provider.

CV: Use the Link Configuration: WAN Dialog Box and select SMDS from the Link Type pull-down menu. Then click on the SMDS button to set addresses.

TB: Use configure and set the StationAddress, IPMulticast and PollingFrequency keywords in the SMDS WAN 0 (and/or

WAN 1) section.

Saving a Configuration File to Flash ROM

Once a configuration is complete, you can save it to the router’s Flash ROM. Until saved, all changes are made in a separate buffer and the actual router interfaces run as before the changes were made.

CV: Use the Save to/Device option from the File menu.

TB: Use the save command.