
2.8 Connecting to a PC or Terminal
The subsystem is equipped with a serial monitor port located at the rear of the system unit. This serves as an alternative display when accessing the setup utility.
Pin | Description |
1 | Data Carrier Detect (DCD) |
2 | Receive Data (RD) |
|
|
3 | Transmit Data (TD) |
|
|
4 | Data Teminal Ready (DTR) |
|
|
5 | Signal Ground (SG) |
|
|
6 | Data Set Ready (DSR) |
|
|
7 | Ready To Send (RTS) |
8 | Clear To Send (CTS) |
9 | Ring Indicator (RI) |
Note:
Refer to Chapter 3 for instructions on accessing the setup utility through a PC or terminal, as well as instructions on setting the baud rate, stop bit, data bit and parity of your monitor or terminal. The default setting of the monitor port is 115200 baud rate,
Getting Started |