20
4.Place the small branch of log#5 into the notch on log#3. The notch on the charred edge of log#5 sits on the outer left grate post.
#6
GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZERTM logs available from your Continental® dealer.
5.Place the small end of log#6 into the front notch of log#4. Place the locating hole in the large end of log#6 onto the locating pin on top of log#2.
#7
LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing door, as indicated.
½"
LOGO |
FIGURE 42 | ½" |
6.Place log#7 onto the pin located on top of log#6. The log should sit in the notch on log#2, and the bottom should rest on the outer right grate post.
#8
7.Place the large end of log#8 into the rear notch of log#4.
The small branch of log#8 sits in the notch located on top of log#1.
#10
#9
8.Place log#9 onto the grate as though it had burnt off log#5. Place log#10 onto the locating pin on log#1. Again, log#10 should be aligned as though it has burnt off of log#7.
CHARCOAL EMBERS
LOUVRE INSTALLATION
The protective wrap is best removed when the assembly is at room temparature but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
A
FIGURE 43
B
| UPPER LOUVRES | |
| Insert the louvre tabs into the slots | |
SLOT | located at the top left and right cor- | |
ners of the unit. | ||
| ||
TAB |
|
A
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner. Fine dust found in the
bottom of the bag should not be used.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to be placed on the burner.
B
HINGE
CLIP
SLOT
LOWER LOUVRES
Insert the hinge clips into the slots located at the bottom left and right corners of the unit.
To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assembly back. Lift the clip.
