IMPORTANT SAFETY INSTRUCTIONS
1.Read these instructions.
2.Keep these instructions.
3.Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordanc e with the manufacturer's
instructions.
8. Do not install near any heat source s such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce h eat.
9. Do not defeat the safety purpose of the pola rized or grounding-type plug. A
polarized plug has two blades. A grounding type plug has two blades and a third
grounding prong. The blades or the third prong is provid ed for your safety. If the
provided plug does not fit into your outlet, cons ultan electrician for replacement of
the obsolete outlet.
10. Protect the po wer cord from being walked on or pinch part icularly at plugs,
convenience receptacles, and the point where they ex it from the apparatus.
11. Only use attachments/acc essories specified by the manufacturer.
12. Unplug this apparatus during lightening storms or when unused for lon g periods of
time.
13. Refer all servicing to quali fied servicing personnel. Servicing is required when the
apparatus has been damaged in any way, such as power supply cord or plug is
damaged, the appliance has been exposed to rain or moistu re,d oes not operate
normally,or has been dropped.
14. This appliance shall not be ex posed to dripping or splashing water, and that no
object filled with liquid such as vases shall be placed on the a pparatus.
PRECAUTIONS
When the set is not going to be used for a long time, unplug the AC lead and remove
the batteries.
Do not leave exhausted batteries in the compartment as they will leak an d cause
corrosionand damage.
Never open the covers or touch the inside or insert a metal object. Any of these
operations could cause an electric shock or a fault.
When thunder starts, unplug the power cord from the AC outlet.
Do not expose the unit to direct sunlight, extreme hea t, and high humidity, or place it
near heat sources, the sea, or in a sa ndy or dusty place.
Do not clean the cabinet of the set with st rong detergents or solvents as these could
damage the surface finish.
We discourage the use of C-120 cassette tapes as they tend to break or jam the
device.
The apparatus should not be exposed to dripping or splash ing.
Discs which can be played on this player have the following markon them:
Do not move the set suddenly from a very cold room into a w arm room. When a
chilled CD player is moved suddenly to a wa rm location, moisture condensation may
form on the pick-up lens, preventing proper opera tion. In this case, wait 1 to 2 hours
before resuming play.
During playback, if the CD player is subjected to a sudden sho ck or jolt, some noise
may be produced, this is not a malfunction.
Do not place any objects in the disc compartment, it may cause damage to the
mechanism.
Remove the disc before moving the set. If theplayer is moved with the disc loaded,
the disc may be damaged.
Do not store discs in high temperature, high-humidity locations. The discs may
develop warps and become unable to play. Also, disc s with moisture on them may be
unplayable.
Wipe any moisture off with a soft, dry clothe, and be sure discs are fully dry before
using.
Handle the discs carefully so that fingerprints and dust d o not adhere to the surfaces
of the discs. To clean off, use a soft cloth. Do not use a hard cloth since these will
mark the disc.
If you switch a fluorescent lamp on or off near the set, you may hear some
interference noise; this is not a mal function.
Safety Check - Upon any completion of service or repairs to this product, ask s ervice
technician to perform safety check to determine that the product is in proper
operating condition.
Servicing - Do not attempt to service this product yo urself as openings or removing
covers may expose you to dangerous voltage or oth er hazards. Refer all service to
qualified servicing personnel.
WARNING: The apparatus shall not be exposed to dripping orspla shing water and that
no objects filled with liquids, such as vases, shall be placed on the
apparatus.
SPECIFICATIONS
Frequency Range FM: 88-108 MHz, AM:530-1710 kHz
Antennas FM: Rod antenna, AM: Built-in ferrite bar
Frequency Response 100 - 15000Hz
Power Output 1.2 W + 1.2 W (RMS)
Power Requirements AC120V , 60Hz
9V DC, "D" size or UM-1 cell x 6
Power Consumption: 13 W in AC operation
Accessory Supplied AC power cord (1)
Instruction Manual (1)
CD PLAYER SECTION
Playback system AutoStop version
Frequencyresponse 100-15000Hz
•No debe exponerse el aparato a goteras o salpicaduras.
•Los discos que puedan reproducirse en este aparato deberán de portar la siguiente marca:
•No traslade el aparato repentinamente de un ambiente frío a uno caliente. Cuando un repro-
ductor de CD que se encuentra frío es trasladado repentinamente a un lugar caliente, se puede
formar condensación de humedad en el lente de lectura, lo que puede interferir con su normal
funcionamiento. En este caso, espere de 1 a 2 horas antes de reanudar su uso.
•Durante la reproducción, si el reproductor de CD es sometido a un golpe o sacudón fuerte, se
puede producir algo de ruido. Esto no indica que haya un desperfecto.
•No coloque ningún objeto dentro del compartimiento del disco ya que puede causar daños al
mecanismo.
•Retire el disco antes de trasladar el aparato. Si se traslada el aparato con el disco puesto, el
disco puede dañarse.
•No guarde o almacene los discos en lugares de alta temperatura o de gran humedad. Los discos
pueden desnivelarse o torcerse y volverse inservibles. Además, los discos con humedad sobre la
supercie quizá no puedan reproducirse.
•Limpie la humedad con un paño suave y seco y asegúrese de que los discos estén totalmente
secos antes de usarlos.
•Manipule los discos con cuidado para evitar que no se adhieran huellas digitales o polvo sobre
la supercie. Para limpiar use un paño suave. No utilice un paño áspero ya que puede arañar el
disco.
•Si se enciende o se apaga una lámpara uorescente cerca del aparato, se puede producir algo
de interferencia, lo cual no indica un desperfecto.
•Revisión de Seguridad – Al nal de una reparación o mantenimiento del aparato, solicite al
técnico que haga una prueba de seguridad para determinar que el producto esté en condiciones
óptimas de funcionamiento.
•Mantenimiento o Reparaciones – No intente reparar el aparato Ud. mismo ya que las aberturas o
el retiro de las tapas pueden exponerlo a voltajes peligrosos u otros riesgos. Todo mantenimiento
debe de ser llevado a cabo por el personal de servicio técnico calicado.
ADVERTENCIA: No debe de exponerse este aparato a goteras o salpicaduras de agua; ni colo-
carse objetos con agua, tales como un orero, encima del aparato.
ESPECIFICACIONES
Rango de frecuencia FM: 88-108 Mhz, AM: 540-1600 kHz
Antenas FM: antena de varilla, AM: Barra de ferrito incorporada
Respuesta de Frecuencia 100 – 15000Hz
Salida de Energía 1.5W + 1.5W (RMS)
Requisitos de Energía AC120 V, 60Hz
9V DC, batería tamaño “D” o UM-1 x 6
Consumo de Energía 15W funcionando en AC
Accesorios incluidos Cable de alimentación AC (1)
Manual de Instrucciones (1)
SECCIÓN DEL REPRODUCTOR DE CD
Sistema de reproducción Versión de detenido automático
Respuesta de Frecuencia 100-15000Hz