Powering Up | VholdR Camera Status | |
|
|
|
Before you power up, make sure your VholdR is in the ‘Stop’ position by sliding the top record switch all the way back against the rear door.
You can check the status of your VholdR camera by pressing and holding the power button for one second after the camera has finished booting.
Note: Do not toggle the record switch or connect to a computer until the unit is fully booted. (Approximately 15 seconds).
Press and hold the power button until the status lights on the back light up, then release.
aThe front red power light will turn on.
bThe rear two lights will stay amber for about 10 seconds.
cNext, the lens lasers will turn on for about five seconds as the back two indicator lights turn off.
CAUTION: DO NOT stare directly into the laser beams.
dFinally, the lasers will turn off and you will hear a beep.
eThe VholdR is now fully booted and ready to record.
fThe red power light will remain on to indicate the VholdR is on and ready to go.
rear | front |
b
b 
c 
press and hold for (1) second
Battery Status |
|
Green light | More than 66% full |
Yellow light | Between 33% and 66% full |
Red light | Less than 33% - time to recharge |
No lights | Recharge your VholdR or power up again |
Memory card status |
|
Green light | More than 66% free recording space |
Yellow light | Between 33% and 66% free recording space |
|
|
Red light | Less than 33% - time to swap out cards or download |
Flashing Red | Your memory card is full, you are missing a card, or |
| your card has an error and needs to be formatted |
| (see Tips & Troubleshooting to format your MicroSD Card) |
Power off | Press and hold rear button for 3 seconds or until all |
| lights turn off |
|
|
10
Powering Up | a, f | VholdR Camera Status |
|
11
