Cooper Bussmann BU-245U-E IP Address Filter Configuration:

48 www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-245U-E Wireless Ethernet & Device Server User Manual
Select “Blacklist”or “Whitelist” Blacklist will prevent all listed devices from accessing the module and using the radio link.
Whitelist will allow devices with the MAC addresses listed to communicate with the module and
utilize the radio link.All other devices are blocked.
Add Entry Add a row to the table of Mac Address filter rules
Delete Entry Delete the currently selected MAC address filter rule.
Enable Check to enable the rule.
MAC Address Enter the desired source MAC Address
Save Changes Save changes to non-volatile memory (Reset is required to activate)
Save Changes and Reset Save to non-volatile memory And restart to activate changes
IP Address Filter Configuration:
The IP filter allows can be used to permit or deny network access to specific devices through the use of Blacklists (blocking of traffic that matches
a rule) and Whitelists (allow traffic that matches a rule).
The IP filter entry will match either source or destination address in the packet. That is,if either the source or destination IP address falls within
the address range specified in the rule, the packet is matched and will be discarded (Blacklist) or allowed (Whitelist).
If the protocol is specified, the protocol of the packet must also match.If the protocol is TCP or UDP the source or destination TCP/UDP can also
be inspected. If the IP address and protocol matches and the source or destination port number falls within the range specified,the packet is
matched.
Note: Configuration pages use TCP protocol on ports 80 and 443. Create Whitelist rules specifying the configuration PC's
IP address, with TCP protocol,ports 80 and 443.
Select “Blacklist”or “Whitelist” Blacklist will prevent all listed devices from accessing the module and using the radio link.
Whitelist will allow devices with the IP addresses listed to communicate with the module and
utilize the radio link.All other devices are blocked.
Add Entry Add a row to the table of IP Address filter rules
Delete Entry Delete the currently selected IP address filter rule.
Enable Check this box to enable the rule
IP Address Min,IP Address Max These set the range of IP addresses. All addresses within the specified range are affected by the rule.
Port Min, Port Max When the protocol is set to TCP or to UDP, this is the range of port addresses to which the rule applies.
When protocol is set to All or to ICMP,these settings have no effect.
Protocol This chooses the protocol to which the rule applies. The rule can apply to Any protocol
(All), or to only one of TCP, UDP,or ICMP (Ping).
Save Changes Save changes to non-volatile memory (Reset is required to activate)
Save Changes and Reset Save to non-volatile memory and restart to activate changes
3A1576Rev1.6