22 www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-245U-E Wireless Ethernet & Device Server User Manual
Method 1 - Set PC to same network as BU-245U-E
Connect the Ethernet cable between unit and the PC configuring the module.
• Set the Factory Default Switch to the SETUP position. This will always start the BU-245U-E with
Ethernet IP address 192.168.0.1XX, subnet mask 255.255.255.0,gateway IP 192.168.0.1 and
the radio disabled. Do not forget to set the switch back to the RUN position and restart the
module at the conclusion of configuration for resumption of normal operation.
• Power up the BU-245U-E module.
• Open “Network Settings” on your PC under Control Panel. The following description is for
Windows XP - earlier Windows operating systems have similar settings.
• Open “Properties” of Local Area Connection.
• Select Internet Protocol (TCP/IP) and click on Properties.
• On the General tab enter IP address 192.168.0.1, Subnet mask 255.255.255.0 and press “OK”
• Open Internet Explorer and ensure that settings will allow you to connect to the IP address
selected. If the PC uses a proxy server,ensure that Internet Explorer will bypass the Proxy
Server for local addresses.
• This option may be modified by opening Tools -> Internet Options -> Connections Tab -> LAN
Settings->Proxy Server -> bypass proxy for local addresses.
• Enter the default IP address for the BU-245U-E https://192.168.0.1XX where XX is the last two
digits of the serial number.
Enter the username “user”and default password “user.”
Figure 1 – Welcome Webpage
3A1576Rev1.6