Corega 613-00041-01 manual Front Panel LEDs, Rear Panel & Connections

ENGLISH

1.2 Front Panel LEDs

The following figure shows the front view of the BAR-WL Wireless Router.

	WLAN	WAN		LAN
	Link	100M
		Link/Act
Power	Act
		Col/Fdx
		1	2	3	4

•	PWR (Power)	Green	Steady on when power is on.
•	DIAG (Diagnostic)	Red	Light up during power on self-check. Not lit in normal operation.
•	WLAN (Wireless LAN)
	Enable:	Green	Steady on when AP (Access Point) is enabled.
	Activity:	Green	Blinking when data is following through AP.
•	WAN (WAN port)
	Link:	Green	Steady on when ADSL/Cable Modem is properly connected.
	Activity:	Yellow	Blinking when data is following through WAN port.
•	LAN (LAN ports)
	Link/Act:	Green	Steady on when link is up and it operates at 100Mbps.
		Yellow	Steady on when link is up and it operates at 10Mbps.
		Green/Yellow	Blinking when data is following through this LAN port.
	FD/Col:	Green	Steady on when it operates at full duplex mode.
			Off at half duplex mode.
			Blinking when collision is occurred on this port.

1.3 Rear Panel & Connections

The following figure shows the rear view of the BAR-WL Wireless Router.

Power WAN 1 2 3 4 Init

•Init Press the Initialization button quickly to reboot and re-initialize the device. Press the Initialization button of longer than 3 seconds to clear any configuration and reset the router back to factory default values.

•WAN This port is for connecting to the Wide Area Network ADSL or Cable Modem.

•LAN 1-4These ports are used to connect computers and peripherals to the BAR-WL.

•Power This socket is used to connect the external power supply to the router.

5