FlavorFusion Installation Manual
Adjusting Syrup/Water Ratio (Brix)
Timed Dispense Procedure
1.Enter programming mode for the valve block by simultaneously pressing and holding both programming buttons for 4 seconds (see FIGURE 4). The LED’s for flavors
2.Set the valve block to a 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until the flash pattern for all for buttons changes.
3.Place the water end of the ratio cup under the appropriate nozzle and press the left program button for a 4 second dispense of carbonated water. (Push the right program button for still water pour.)
4.Place the syrup end of the ratio cup under the nozzle and press the appropriate flavor button for a 4 second dispense of syrup. The fill line should be the same for both water and the syrup. Adjust the syrup flow control if necessary, then empty cup and repeat steps 3 and 4.
5.Repeat for all syrups in valve bank.
6.Exit 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until the flash pattern for all for buttons changes.
7.Exit programming mode by simultaneously pressing and holding both programming buttons for 4 seconds.
Setting a Button to Dispense Non-carbonated Water Only
1.Program the designated button to dispense
2.Do not connect a syrup source to the inlet circuit of the designated button
Setting a Button to Dispense Carbonated Water Only
1.Program the designated button to dispense carbonated water (see Programming Mode.)
2.Do not connect a syrup source to the inlet circuit of the designated button
NOTE: The ambient circuits A1 and A2 do not give up a cold plate circuit.
Back Room Package Position (BRP)
C
D 
G 
H E 
F 
I 
J
C 
D
E
F
G 
H
I 
J
K
L 
O 
P M 
N 
Q 
R
K
L
M 
N
O 
P
Q 
R
S
T 
W 
X U 
V 
Y 
Z
S
T
U 
V
W 
X
Y 
Z
Pumps
BIB Racks
FIGURE 5
Publication Number: 621057601INS | - 8 - | © |
