FlavorFusion Installation Manual
Setting Water Flow Rate
Setting the water flow rate will require a timed dispense. To accomplish this, the following procedure should be followed:
1.Enter programming mode for the valve
block by simultaneously pressing and holding both programming buttons for 4 seconds (see FIGURE 4). The LED’s for flavors
2. | Set the valve block to a 4 second pour |
|
| mode by simultaneously pressing and |
|
| holding Flavor 1 and Flavor 4 buttons until | Flow Adjuster Detail |
| the flash pattern for all four buttons | |
| (Water) | |
| changes. | |
|
| |
3. | Place an empty ratio cup under the |
|
| appropriate nozzle and press the left |
|
| program button for a 4 second dispense of |
|
| carbonated water. There should be |
|
| approximately 10 oz. dispensed. |
|
4. | If necessary, adjust the water flow control |
|
(see FIGURE 3), empty ratio cup, and | FIGURE 3. Valve with Flow Adjusters | |
(see plumbing diagram for plumbing and valve | ||
repeat step 3. Otherwise empty ratio cup | ||
configuration) | ||
and repeat step 3 using the right program | ||
| ||
button for plain water. |
|
5.Exit 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until the flash pattern for all for buttons changes.
6.Exit programming mode by simultaneously pressing and holding both programming buttons for 4 seconds.
Bonus Flavor
Programming Buttons
(Left
and Right)
Optional
Bonus Flavor Icon
Optional
Bonus Flavor Button 1 Optional
Bonus Flavor Button 2 Optional
Bonus Flavor Button 3
Optional
Bonus Flavor Button 4
Optional
Bonus Flavor Nozzle Optional
Brand Flavor
Programming Buttons (Left and Right)
Drink Icon
Brand Flavor Button 1
Brand Flavor Button 2
Brand Flavor Button 3
Brand Flavor Button 4
Brand Flavor Nozzle
FIGURE 4
© | - 7 - | Publication Number: 621057601INS |