Connecting the DR
The following procedure is for connecting the DR
1. Back up your Tow Vehicle so that the Hitch of the Vehicle is in line with and next to the
| Hitch on the DR | |
| TILLER. Set the Parking Brake on the Tow | |
Clevis Pin | Vehicle. | |
2. Adjust the height of the Clevis on the Hitch | ||
| ||
| on the DR | |
| using the Control Box for the Actuator so | |
| the Clevis is ready to attach to the Hitch of | |
Clevis | the Tow Vehicle. | |
Pins | NOTE: The height of machine is adjustable by +/- | |
| ||
| 3" by removing the two (2) Clevis Pins | |
| (Figure 11) and | |
Clevis | up or down. The lower the front of the | |
| frame, the deeper the Tine depth for | |
Hair Clevis Pin | tilling, but you will lose transport height. | |
| ||
| 3. Remove the Hair Clevis Pin and Clevis Pin | |
| from the Clevis. Back the Tow Vehicle so | |
Figure 11 | the Hitch on the Tow Vehicle goes into the | |
| Clevis. Set the Parking Brake on the Tow | |
| Vehicle and reinstall the Clevis Pin and Hair | |
| Clevis Pin (Figure 11). |
Attaching the DR ROTO-HOG POWER TILLER Control Box
The following procedure includes the steps necessary for attaching the DR
•Hang the Control Box by the attached
•Attach the Control Box on a clean flat surface using the
| Attached | NOTE: | To prevent the Control Cable from | ||
|
|
|
| ||
|
|
|
| Loop Strip | entering the Tines during |
|
|
|
| operation, coil up any excess Cable | |
|
|
|
|
| |
Mate up and |
| and secure with a Cable Tie. | |||
push together. |
| Make sure you leave enough Cable | |||
|
|
|
|
| length to accommodate turns. |
|
|
|
|
|
|
| Hook Strip attached to |
|
| back side of Control Box. |
|
| Control Box | Clean flat surface |
| Figure 12 | on Tow Vehicle. |
|
| |
20 | DR® |
|