Lubrication
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
Your DR
Supplies Needed:
•Grease Gun w/General purpose grease
NEVER OIL OR GREASE PIVOT POINTS. VISCOUS LUBRICANTS WILL ATTRACT DUST AND DIRT THAT CAN CAUSE WEAR ON PIVOT POINTS. IF YOU FEEL YOU MUST LUBRICATE THEM, USE ONLY DRY POWDERED GRAPHITE TYPE LUBRICANTS.
Tines Shaft:
Grease the Tines Shaft using a Grease Gun with General Purpose grease every 8 – 10 hours. Apply about ten (10) pumps of the grease in the Grease Fitting (Figure 18). Perform this lubrication more often in dry and dusty environments.
Grease
Fitting
Figure 18
30 DR®
