CHAPTER 5
MAINTAINING THE DR ROTO-HOG POWER TILLER
This chapter covers regular maintenance procedures that will ensure the best performance and long life of your DR
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
Regular Maintenance Checklist
NOTE: Consider that the service intervals shown are the maximum under normal operating conditions. Increase frequencies under extremely dirty or dusty conditions.
Procedure | Before Each | Every | Every 35 | |
Use | Hours | Hours | ||
| ||||
Check the Engine Oil Level | ▲ |
|
| |
|
|
|
| |
Clean the Tines and Debris Shield* | After each use |
|
| |
|
|
|
| |
Check the general condition of the machine, | ▲ |
|
| |
e.g. nuts, bolts, welds, etc. |
|
| ||
|
|
| ||
Clean Engine Exterior & Cooling Fins | ▲ |
|
| |
|
|
|
| |
Check the Tines Shear Pins for wear | ▲ |
|
| |
|
|
|
| |
Grease the Tines Shaft |
| ▲ |
| |
|
|
| ||
Check Battery Voltage |
| ▲ |
| |
|
|
|
| |
Clean Air Filter |
| ▲ |
| |
|
|
|
| |
Inspect the Tine Drive Belt for wear |
|
| ▲ | |
|
|
| ||
Check Tines for Wear |
|
| ▲ | |
|
|
| ||
Change Engine Oil |
|
| ▲ | |
NOTE: 1st time 5 hrs. |
|
| ||
Replace Air Filter and |
|
| ▲ | |
|
|
| ||
Replace the Tine Drive Belt |
|
| ▲ | |
|
|
| ||
Replace Spark Plug |
|
| ▲ | |
|
|
|
*Cover the Engine Muffler, Carburetor, and Air Filter before using a hose to clean the Tines and Debris Shield. Do not use a power washer; this may force water through the seals of the Actuator.
CALL TOLL FREE | 29 |