Negative |
|
Terminal | Battery Bar |
Positive
Terminal
Figure 4
Figure 5
Fuses
Fuse Location in
Front of Battery
1/4" x
5.Place the Battery in the Battery Bracket and secure it using the Battery Bar with two (2) 1/4" x
6.Using a 1/2" Wrench or Socket, remove the three (3) screws securing the
7.Using the two (2) 4" Pins and
8.Using a 1/2" Wrench, remove the four (4) Bolts from the Axle
NOTE: At this point, you will have two (2) Screws from the Hitch, four (4) Screws from the Axle Brackets, and the two (2) Axle Brackets. All this hardware was for shipping and is NOT required for assembly.
9.Using two (2) 5/16" Wrenches, attach the Battery Cables to the Battery (Figure 4).
10.Using the Control Box (Figure 8 on page 15), lower the Tines all the way down, which will raise the Wheel Axles from the pallet.
11.Slide a Wheel onto each Axle making sure that the Wheel Valve Stem is to the outside (Figure 9 on page 15).
12.From the Hardware Bag, place one (1) Flat Wheel Washer on each Axle, slide a Cotter Pin through the Hole in the Axle on each side, and spread the Cotter Pin Legs using Pliers (Figure 9 on page 15).
13.Raise the Tines, lowering the Wheels, and roll the machine from the shipping pallet. Do not discard your packaging material until you are fully satisfied with your new DR
4" Pins | Bow Tie |
| Cotter Pins |
Figure 6
14 DR®