Installation
STEP 9 Install Door Bracket and Plate
Follow instructions which apply to your door type as Illustrated below.
ALWAYS RE NFORCE THE NSIDE OF
The horizontal brace should be st least 6 feet long. The vertical brace should cover height of top panel. Check with your garage door manufacturer for a door re=nforcement kit for an opener installs[ion.
Sectional Door Installation Procedure
Header
B_acket
VeStal | SECTIONAL DOOR |
Center |
|
Line |
|
DoorBradder& plate Assy,
Top of Door
1.Assemble door bracket and plate as shown. Center bracket on previously marked vertical guideline.
2.Position the bracket assembly on the face of the door within the following limits:
A)The top edge of the bracket 2"- 4" below the top edge of the door.
B)Directly below any structural support across the top of the door.
Placement depends on your particular needs.
3, Mark and drill 5/16" TOP and BOTTOM fastening holes, Secure bracket as shown.
DoorBrad_t
Ptate
Nut
Reinfomernent
Board far
Lightw_ht Doors
ReinforcementBoard
Washer 5/16"
One-Piece Door Installation Procedure
NOTE: Door bracket has left and right side fastening holes. Assemble and install the door bracket and plate if your installation requires top and bottom fastening holes.
1, Center bracket (with or without plate as required) on top edge of door as shown. Mark holes.
2.Drill two 5/16" holes and fasten the door bracket with hardware supplied.
NOTE: If the door has no exposed framing, drill 3/16" pilot holes and use 5/16" x
NOTE: The door bracket may be installed on face of door if required for your installation. (Refer to dotted line drawing.) HOWEVER, drill 3/16" pilot holes and substitute 5/16"x
ONEPIECEDOOR
Door--HeaderWall
Bracket
Optional | DoorBracket | |
Face of Door | ||
Plate | ||
Inst.'zllation | ||
| (Optional) | |
Vertical |
| |
| ||
Une |
|
15