Assembly
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL INSTRUCTED TO DO SO.
STEP 1 Assemble Tee Rail & Attach Cable Pulley Bracket
TEE RAIL BACK (TO CHASSIS)
Tee Rail
(End Section)
CAUTION: Do not _ghten the lock nuts until bolt necks rre seated in square holes.
1/4" Lodx Nut
TeeRail Br_. (CemerSec_on)
The end section,, of the rail MUST be connected to the center section from the direction shown in the illustration. Otherwise, the trolley will hit against the nut when installed (Pg. 7).
Brace
Tee Rail
(End Se_on)
SquareCarriage
Bob Holes
Cablepulleybracket
attachestoFRONT
ENDofteerail
\
RAIL FRONT (TO DOOR)
PROCEDURE: Place the 3 Tee rail sections on a flat
surface for assembly. THIS IS IMPORTANT. The end sections are identical. THE CENTER SECTION BRACES MUST BE POSITIONED AGAINSTTHE END SECTIONS AS SHOWN. Make sure that the "directional arrow"is
pointing toward the front (to deer). Study the illustration
CAREFULLY.
(When assembled, Tee rail has a
Bolt rail sections together with the hardware illustrated and from the direction indicated.
SQUARE NECKS ON THE CARRIAGE BOLTS MUST BE SEATED IN THE SQUARE HOLES IN RAIL SECTIONS.
Screws
Cable Pulley
Bradder
Lock Washer | Nut |
5/16" |
|
Position the cable pulley bracket on front end of tee rail as shown. Fasten securely with the hardware provided.
IMPORTANT: When tightening screws, be sure to keep bracket parallel to rail. Otherwise, rail may bow when opener is operated.
