Installation
STEP 2 Attach Tee Rail to Header Bracket
Header
Bracket
Cle_s Pin
PROCEDURE: Position opener chassis on garage floor below the header bracket. Use packing material base to protect cover. NOTE: To enable the Tee rail to clear sectional door springs, it may be necessary to lift the chassis onto a temporary support.
CAUTION: Chassis must either be eecured to support or held firmly in place by another person.
Raise the Tee rail until pulley and header brackets come
together. Align bracket holes and join with clevis pin as shown. Insert ring fastener to secure.
Packing
MaterLal
STEP 3 Position Opener Chassis
Follow only those instructions which apply to your door type as illustrated.
TO PREVENT DAMAGE TO ALL LIGHTWEIGHT DOORS AND DOORS WITH WINDOWS, DO NOT REST
THE OPENER ON THE DOOR.
INSTALLATION
SECTIONAL &
DOOR WITH TRACK
NOTE: A 2x4 is convenient for setting an ideal door-
PROCEDURE: Raise the opener chassis onto a step- ladder. Open garage door. Place a 2x4 on top section of door near centerline as shown below. Rest Tee rail on 2 x4.
INSTALLATION
WITH NO TRACK
PROCEDURE: Measure the distance from floor to top of door (in fully open position and parallel to the floor).
Using a stepladder as a support, raise opener chassis to
the same distance from the floor (chassis will have a slight angle as shown).
The top of the door should be level with the top of opener. For maximum efficiency, do net position opener chassis more than 2 inches above this point.
Tee Rail | 2x4 |
| Header |
Top of Opener
from FlOOr
11