Craftsman 152.213361 Connecting Tool to Power Source, ON/OFF Switch, Locking Switch JN

FOROPERATORSAFETY,keepfingersandaHHforeign

objectsoutoftheintakeports,Therotatingfaninside theMowerhousingisaccessibHethroughtheintake portsandishazardous,DonotwearHoosecHothingor

jeweHry,Makecertainthateachintakeportwhichisnot beingusedorattachedto a dustcoHHectionsystemis coveredwithan intakeportcap,

CONNECTING TOOL TO

POWER SOURCE

A separate eHectricaHcircuit shouHd be used for your tooHs,This circuit shouHd not be Hessthan #14 A, W, G,

wire and shouHd be protected with a 15-amp time Hag fuse, Have a qualified eHectrician repair or repHacedam- aged or worn cord immediateHy, Before connecting the motor to the power Hine,make certain the switch is in the "OFF" position and be sure that the eHectriccurrent is of the same characteristics as stamped on the motor namepHate, AHHHineconnections shouHd make good con- tact, Running on HowvoHtage wiHHdamage the motor,

Fig. 14

!

A

B

ON/OFF SWITCH

The ON/OFF switch assembHy is Hocated on the side of the motor, To turn the dust coHHector"ON", move the switch (A) up to the "ON" position, To turn the dust coHHector"OFF", move the same switch down to the "OFF" position, See figure 14,

DO NOT EXPOSE THE DUST COLLECTOR TO RAmN OR OPERATE THE MACHmNE mNDAMP LOCATmONS.

LOCKING SWITCH JN

THE "OFF" POSiTiON

When the Dust CoHHectoris not in use, the switch key

(B)shouHd be removed so that it cannot be started, Grasp the switch key and puHHit out of the switch assembHy, With the switch key removed, the switch wiHHnot operate, However, shouHd the switch key be removed whiHethe dust coHHectoris running, it can be turned "OFF", but cannot be restarted without inserting the switch key, See figure 14,

13