Carburetor
WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts. Be careful of heated surfaces and mufflers.
Minor carburetor adjustments may be required to compensate for differences in fuel temperature, altitude and load.
Service
Augers
The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. See Figure 23. If you hit a foreign object or ice jam, the snow thrower is designed so that the bolts will shear. This type of boltt is used where vibration occurs.
If the augers do not turn, check to see if the bolts have sheared. Two replacement shear bolts (shown in Figure 23 inset ) and hex lock nuts have been provided with the snow thrower. Since lock nuts cannot be threaded onto a bolt by hand, use a wrench. When replacing bolts, spray an oil lubricant into shaft before inserting new bolts.
Auger
Hex Lock
Nut
Shear Bolt
Figure 23
Shave Plate and Skid Shoes
The shave plate and skid shoes on the bottom of the snow thrower are subject to wear. They should be checked periodically and replaced when necessary.
•Remove the six carriage bolts, belleville washers and hex nuts which attach skid shoes to the snow thrower on two sides. See Figure 17.
•Reassemble new skid shoes with the six carriage bolts, belleville washers (cupped side goes against skid shoes) and hex nuts. Make certain the skid shoes are adjusted to be level.
•To remove shave plate, remove the skid shoe first. Next remove carriage bolts, belleville washers and hex nuts which attach shave plate to the snow thrower housing. For location of shave plate, see Figure 24.
•Reassemble new shave plate, making sure heads of the carriage bolts are to the inside of the housing. See Figure 24. Reinstall skid shoe. Tighten all hardware securely.
Washer | Washer |
| Washer |
Carriage Bolt |
|
|
|
Hex Nut | Carriage Bolt | ||
|
|
| |
Figure 24
Replacing Belt
WARNING: Disconnect the spark plug wire from the spark plug and ground.
Auger Belts
•Remove the plastic belt cover on the front of the engine by removing the two
Engine
Screw
Belt Cover | |
Screw |
|
Auger Housing |
|
Figure 25
•Disconnect chute crank assembly at the discharge chute by removing the hairpin clip and the two flat washers. See Figure 26.
21
