Attaching Chute Crank
• | On the left side of the handle panel, place the |
| upper chute crank bracket on to the inside of the |
| handle panel support. See Figure 5. You will find |
| this bracket and associated hardware in group F |
| of hardware pack. |
•Place one 3/8 ID flat washer (from group G of the hardware pack) on the end of the chute crank, then insert the end of the chute crank into the eye hole in the plastic bushing in the lower chute crank bracket. See Figure 7.
• | Insert hex bolt through the upper chute crank |
| bracket, handle panel support, and upper left |
| handle. Secure the bracket using cupped |
| washer and hex nut. Make sure that the cupped |
| side of the washer is set against the handle. |
| Nut | |
Handle Panel |
| Washer |
Support* |
| |
|
| |
Hairpin Clip
Flat
Washer
Plastic
Bushing
Chute Crank
Flat
Hex Bolt
Upper Chute
Crank Bracket
*This part is already attached inside the handle panel
Figure 5
•You may have to loosen the carriage bolts and hex lock nuts which secure the lower chute crank bracket to the extension on the left side of the chute assembly. See Figure 6.
Chute
Assembly
Lower Chute | Carriage Bolt, | |
Hex Nut | ||
Crank Bracket | ||
|
Figure 6
Lower Chute Washer
Crank Bracket
Figure 7
•Place the other 3/8 ID flat washer (from the same group of hardware) on the end of the chute crank and insert hairpin clip into hole at the end of the chute crank. See Figure 7.
•Adjust the chute bracket so that the spiral on the chute crank fully engages the teeth on the chute assembly.
Upper
Chute
Crank
Upper
Chute
Crank
Bracket
Hairpin
Clip
Lower Chute
Crank
Figure 8
•Slide the upper chute crank through the plastic bushing in the upper chute crank bracket and then into the lower chute crank. See Figure 8. Align the holes on the two pieces of the chute crank, and secure with hairpin clip from group C of the hardware pack.
•Fully rotate the chute, using the chute crank, to make sure that it moves freely.
8
