Craftsman 315.11534, 350 manual See Rgure, See F/gum

A

WARNING: 6artery tools are a(ways in operatirtg conditfon. Therefore, the switch should always be locP.ed when not in use or carrying at you_" side.

SWITCH TRIGGER

See Rgure 4.

To turn the driJlON, depress the switch trigger.To turn it

OFF, release the switch trigger.

VARIABLE SPEED

See F/gum 4.

The variable speed switch triggerdelivers higher spee(J and torque wi_ increased _gger pressureand lower speed with decreased trigger pressure.

NOTE= You might hear a whistling or ringing noisefrom the switch during use. Do not be concerned; this isa nor- mal part of the switch function.

DIRECTIONOFVARIABLESPEED

HOTA'I"[ONSELECTORSWITCHTRIGGER

(FORWARD/ REVERSE REVERSE

/ _ LOCK)

Avoid runningthe drll_at low speeds for extswdedperiods

of Lime.Runningat low speeds under constantusage may cause the drillto become overheated. If this occurs, cool the drillby running it without a load and at full speed.

KEYLESS CHUCK

See Figure 5.

The drin-driverhas a keytese chuck to tighten or release dd[[ bits in the chuck jaws. Grasp and holdthe collar of the chuckwlth one hand. Rotate the chuck body with your other hand. The arrows on the chuck indicate which direc- tion to rotate the chuck body in order to LOCK (tighten)or

UNLOCK (release)the dr_UbiL

dl_ WARNING: Do not hold the chuck body with one hand and use the power of the dn'llto tighten the chuck jaws on the dd]] bit. The chuck body could slip in your hand, or your hand could sI_pand come in contact with the rotating drtnbit. This could cause an accident resulting in serious personalInjury.

UNLOCK

DRILLBIT (RELEASE)

!JAWS

FORWARD Fig. 4

FORWARD/REVERSE/CENTER LOCK See FTgure4.

"['hedirection of bit rotation is reversibleand is controlled

by a selector located above the switch trigger. With the driftheld in nom_aloperating position, the direction of

rotationselector shou[d be positionedto the left of the switch trigger for drilling.The ddflingdirection is reversed when the selector isto the right ot the switch t_gger.

Setting the switch trigger in the OFF (car_er look) position

helps reduce the possibilityof accidental starting when not in use.

CAUTION: To prevent gear damage, always allow the chuck to come to a complete stop before chang- ing the direction of rotation.

To stop the drill, release the switch trigger and allow the chuck Locome to a complete stop.

NOTE: The drillwill not run unlessthe direction of rotation selector is pushed fully to the left or right.

LOCI(

(TIGHTEN) CHUCK

BODY

Flg"5

12