SWITCH REPLACEMENT
See Figures 15 and 16.
•Unplug your router,
_k WARNING: Failure to unplug your router could result in accidental starting causing
serious injury.
•Remove screws (A) and handle cover (B). See Figure 15.
•Make lead connections to new switch. Push each lead as far as possible into proper switch receptacle. Pull on leads to check lead connections with lead receptacles.
•Locate switch in handle and place leads so they won't be pinched or contact screws when handle cover is replaced.
•Make sure molded bend relief (C) is correctly positioned in switch handle, then replace handle cover and screws.
•Tighten all screws securely.
B
c
.15
LIGHT BULB REPLACEMENT
See Figure 17.
•Unplug your router.
,_k WARNING: Failure to unplug your router could
result in accidental starting causing serious injury.
•Remove cutter from router. Refer to page 7 to remove cutter.
•Adjust router to maximum height.
•Remove screws (A) and subbase (B). See Figure 17.
•Note the location of the molded bend relief (C) on the power handle cord. Also note all wiring in the handle and how each lead is connected to the switch. Connections and wiring position must be identical when installing new switch.
See Figure 15.
•Remove leads from switch (D) by inserting a 1/32 in. diameter nail or pin into switch lead receptacle and pulling on lead as shown in Figure 16.
Remove nail or pin with a twisting, pulling motion.
LEAD
POWER
HANDLE
CORDWORK LIGHT
1/32in. DIAMETER
NAILOR PIN
WHITE
REDRED
BLACK
Fig. 16
c
D | i | B |
iE
17
•Remove screw (C) and work light lens (D).
•With bulb (El pointing toward you, push bulb in and turn to the left to remove from bulb socket.
Note: Light bulb removal and installation is similar
to removing and installing a standard automotive bulb.
•Install new bulb by reversing the above procedure.
•Reassemble all parts and tighten screws securely.
15
