DEPTH OF CUT ADJUSTMENTS

See Figures 4, 5, and 6.

We recommend that cuts be made at a depth not exceeding 1/8 in. and that several passes be made to reach depths of cut greater than 1/8 in.

Unplug your router.

_1 WARNING: Failure to unplug your router could result in accidental starting causing

serious injury.

Place your router on a flat surface, loosen locking knob, and turn depth adjusting ring until cutter is inside subbase. See Figure 4.

TO

TIGHTEN

LOCKING

KNOB

TO

DEPTH

ADJUSTING

RING

DEPTH

RING

 

INDICATOR

 

CUI"I'ER

POINT

 

 

 

INSIDESUBBASE

'SUBBASE

Fig, 4

Turn depth adjusting ring until tip of cutter touches flat surface. Turn the depth indicator ring until the zero lines up with the indicator point on the base. Note: The depth indicator ring is also a zero reset indicator when setting cutter at zero depth of cut, then it becomes the depth adjusting ring.

See Figure 5.

CUI"FERAT ZERO

_.,._

DEPTHOF CUT

Fig. 5

Position your router so that the cutter can extend below the subbase for desired depth setting. See Figure 6.

CuI-rER EXTENDED

BELOWSUBBASE

Fig. 6

Turn the depth adjusting ring to obtain the desired depth of cut. The distance the cutter moves can be read on the depth adjusting ring. Each mark on the depth adjusting ring indicates 1/16 inch change in depth setting. Indicator point is located on the base.

Tighten locking knob securely before operating router.

8

Page 8
Image 8
Craftsman 315.17513 owner manual Depth of CUT Adjustments, Unplug your router, Cuiferat Zero Depthof CUT, CuI-rER Extended