INSTALLING SCALE INDICATOR

See Figure 7.

Attach the bevel scale indicator to the saw'frame below the scale using the screw supplied,

ANGLEADJUSTMENTKNOB

ANGLEBRACKET

TABLELOCKKNOB SCALEINDICATOR

SCALE

Fig. 7

INSTALLING THE TABLE

See Figure 8.

Slide the table onto the angle bracket from the beck of the saw to front, with the blade traveling through the slot in the table,

TRUSSHEAD

SCREW

FLATHEAD

SCREW(S)

Align the three holes on the table with the three holes in the angle bracket. Fasten the table to

the angle bracket using the three flat head screws and three hex nuts.

Assemble the truss head screw and wing nut to the edge of the table at the end of the slot. Snap the throat plate in place on the table.

Note: The wing nut goes below the table.

MOUNTING BAND SAW TO

WORKBENCH

See Figure 9.

If the band saw is to be used in a permanent applica- tion, we recommend that you secure it in a permanent location such as a workbench. When mounting the saw to a workbench, holes should be drilled through the supporting surface of the workbench using dimen- sions illustrated.

Each leg should be belted securely using 5/16 in. diameter machine screws, lock washers, and 5/16 in. hex nuts (not included). Screw length should be 1-314 in. plus the thickness of the bench top.

Locate and mark the holes where band saw is to be mounted.

Drill (4) 318 in. diameter holes through work- bench.

Place band saw on workbench aligning holes in the frame with holes drilled in the workbench.

Insert all four 5116 in. screws and tighten se- curely with lock washers and hex nuts.

Note: All belts should be inserted from the top. Install the lock washers and hex nuts from the underside of the bench.

Supporting surface where band saw is mounted should be examined carefully after mounting to insure that no movement during use can result. If any tipping or walking is noted, secure workbench or supporting surface before beginning cutting operations.

t

3-1/8in

 

18 in.

 

 

--e

 

 

e

 

i HEX NUT(S)

 

 

 

 

5-3/4in.

 

 

3/8 in. Dia.

 

 

 

12in`

 

WINGNUT

 

 

 

 

!,

\

 

Fig. 8

 

 

 

 

!

 

 

 

 

I

 

J

3-1/8_Lin[L.

!

11 in.

"-

 

 

-I

3.1/2 in.

 

 

3-1/2in.

 

Fig. 9

12

Page 12
Image 12
Craftsman 315.2145 Trusshead Screw Flathead Screws, Mounting Band SAW to Workbench, 8in HEX Nuts 4in In. Dia 12in`