4.Remove the spark arrestor cover.
5.Remove the spark arrestor screen from the spark arrestor cover (Fig. 28).
6.Clean the spark arrestor screen with a wire brush or replace it.
7.Reinstall the spark arrestor screen, spark arrestor cover and screws.
CLEANING
turn your unit off and allow it to cool before you clean
I A WARNING"or service it. To avoid serious personal injury, always
Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic housing or handle. Wipe off any moisture with a soft cloth.
STORAGE
•Never store the unit with fuel in the tank where fumes may reach an open flame or spark.
•Allow the engine to cool before storing.
•Lock up the unit to prevent unauthorized use or damage.
•Store the unit in a dry,
•Store the unit out of the reach of children.
LONG TERM STORAGE
If you plan on storing the unit for an extended time, use the following storage procedure:
1.Drain all fuel from the fuel tank into a container with the same
2.Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from the carburetor.
3.Allow the engine to cool. Remove the spark plug and put 1 oz. (30 ml) of any high quality motor oil or
NOTE: Remove the spark plug and drain all of the oil from the cylinder before attempting to start the trimmer after storage.
4.Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or bolts. The unit is ready for storage.
TRANSPORTING
•Allow the engine to cool before transporting
•Drain fuel from unit
•Tighten fuel cap before transporting
•Secure the unit while transporting
13
