WARNING: To | ensure safety | and reliability, | all repairs should | be performed | ] |
I by a qualified service | technician at | a Sears Service | Center. |
|
GENERAL
Only the parts shown on the parts list are intended for repair or replacement by the customer. All other parts represent an important part of the double insulation system and should be serviced only be a qualified Sears@ service technician,.
A WARNING: For your safety, ALWAYS turn off switch and unplug router motor from the power source before performing any maintenance or cleaning.
tthas been found that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fiber glass boats and sports cars, wallboard, spackling compounds or plaster.. The chips and grindings from these materials
are highly abrasive to electrical toot pads, such as bearings, brushes, commutators, etco
Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compound or plaster. During any use on these materials, it is extremely important that the tool is cleaned frequently by blowing with an air jeL
during power tool operations, or when blowing dust. If operation is dusty, also
A WARNING: Always wear safety goggles or safety glasses with side shields wear a dust mask.
ROUTINE MAINTENANCE
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can l Z_ WARNING: DO NOT at any time let brake fluids, gasoline,
damage, weaken or destroy plastic, which may result in serious personal injury.
1.When work has been completed, clean the tool to allow smooth functioning of the tool over time.
2.Use clean damp cloths to wipe the tool.
3.Check the state of all electrical cables°
4o Keep the motor air openings free from oil, grease and sawdust or woodchips, and store tool in a dry place°
5.Be certain that all moving parts are welt lubricated, particularly after lengthy exposure to damp and/or dirty conditions°
_ WARNING: For your safety, ALWAYS turn off switch and unplug router
motor from the power source before performing any maintenance or cleaning.
Refer to Collet/Nut Care and Cutter Bits on page 16 for cleaning care.
30
