Craftsman 358.351080 manual Fil! Cap, opening, grasp with fingersand remove from tank

CUSTOMER RESPONSIBILITIES

REPLACE FUEL FILTER (Fig. 33, 34 & 35)	Pliers
The fuel filter shouldbe replaced after each season,Never
	\
operate your saw without a fuel filter. Be careful not to
damage fuel line while removingthe fuel filter.

•Run fuel tank dry of fuel before proceedingwith this step.

•Remove fuel cap and allowit to hang to side of motor.

•Using a small pair of needle nose pliers, grasp fuel cap retainer, holding it in tank opening and pull out.

÷....	• With cap out of tank, use a small section of bent wire
	similar to that shown in the illustrationto catch fuel line
	and slowly pull from tank.When fuel filter appears in	Fil! Cap
	opening, grasp with fingersand remove from tank.	Figure33

•Once filter is out of tank, hold fuel line close to fuel filter.

Remove fuel filter by twisting arid pulling at the same time.

•Replace fuel filter.

•Reverse process for installation.

Figure34

Fuel Line Barrel

Filter Neck _ _)

Figure35

:::%:

.-.,,Z =

Fuel Filter

•}

- 21 -