5.Allow unit to run for 5 seconds, then
fully squeeze the throttle trigger to disengage the starting system (start lever returns to RUN position).
STARTING A WARM ENGINE
1.Squeeze and hold the throttle trig- ger.
2.Pull starter rope handle with a con-
trolled and steady motion while squeezing throttle trigger until en- gine starts and runs.
NOTE: Normally, the warm starting
procedure can be used within
the unit sits for more than 10 minutes
without being used, it will be neces- sary to start the unit by following the steps under STARTING A COLD EN- GINE or following the starting instruc- tion steps shown on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing the start lever to the RUN posi- tion. Fully squeeze throttle trigger.
Pull the starter handle repeatedly while squeezing throttle trigger until engine starts and runs. This could re- quire pulling the starter handle many
times, depending on how badly the unit is flooded.
If the unit still doesn't start, refer to the TROUBLESHOOTING TABLE or call
CRAFTSMAN ®
CONVERTIBLE TM FEATURE
This model is equipped with a coupler which enables optional attachments to
be installed. The optional attachments are:
Edger | 358.79240 |
Cultivator | 358.79241 |
Blower | 358.79242 |
Brushcutter | 358.79244 |
Pruner | 358.79245 |
&WARNING: | Always stop unit |
and disconnect spark plug before re- moving or installing attachments.
REMOVING TRIMMER ATTACH- MENT (OR OTHER OPTIONAL AT- TACHMENTS)
CAUTION: When removing or instal- ling attachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Upper Shaft
Coupler
Attachment
TIGHTENKnob
2.Press and hold the locking/release button.
Locking/Release
Button
/ | o |
|
Attachment cup er _ | Upper Shaft | |
3.While securely holding the engine and upper shaft, pull the attach-
ment straight out of the coupler.
INSTALLING OPTIONAL ATTACH- MENTS
1.Remove the shaft cap from the at- tachment (if present).
2.Position locking/release button of attachment into guide recess of coupler.
3.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the
knob securely by turning clock- wise.
Coupler Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
,'_WARNING: Make sure the lock-
ing/release button is locked in the pri- mary hole and the knob is securely tightened before operating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment op- erator's manual. Using the wrong hole could lead to serious injury or damage to the unit.
13
