INSTALLING OPTIONAL ATTACH- MENT
1.Remove the shaft cap from the at- tachment (if present) and discard.
2.Position locking/release button of attachment into guide recess of upper shaft coupler.
Upper Locking/ Attachment
Shaft Release
Button
3.Push the attachment into the cou-
pler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the
knob securely by turning clock- wise.
INSTALLING ATTACHMENT HANGER
An attachment hanger is provided for storage when attachment is not in use. To install hanger on attachment:
1.Remove the shaft cap from the at- tachment (if present) and discard.
2.Press and hold the locking/release button.
3.Push hanger onto the attachment until the locking/release button snaps into the hole.
OPERATING POSITION
ALWAYS WEAR:
Eye Protection
Long Pants
Heavy, i_
Boot
NOTE: This brushcutter attachment is not designed for use with electric pew- erheads.
When operating unit with brushcutter attachment, clip shoulder strap onto
upper shoulder strap clamp, stand as shown and check for the following:
•Wear eye protection and heavy clothing.
•Keep arms extended with right hand holding the trigger handle of power- head.
•Keep left arm extended with left hand holding the handlebar.
•Keep unit below waist level.
•Shoulder strap pad should be cen- tered on your left shoulder and dan- ger sign centered on your back.
•Maintain full weight of tool on left shoulder.
•Without bending over, keep the blade near and parallel to De ground and not crowded into material being cut.
OPERATING INSTRUCTIONS FOR USE OF BRUSHCUTTERATTACH-
MENT WITH TRIMMER HEAD
£A_
I_WARNING: Always wear eye
protection. Never lean over the trim-
merhead. Rocksordebriscan rico- chet or be thrown into eyes and face and cause blindness or other serious injury.
Before trimming, bring engine to a
speed sufficient to cut matedal to be trimmed.
Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full _rottle. At lower speeds, there is less engine noise and vibration. Al- ways release the throttle trigger and allow the engine to return to idle speed when not cutting.
CUTTING METHODS
£A_
aWARNING: Use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc.), which can damage the trimmer head, become entangled
in the line, or be thrown causing a seri- ous hazard.
•The tip of the line does the cutting. You will achieve the best perform- ance and minimum line wear by not crowding the line into the cutting
area. The right and wrong ways are shown below.
Tip of line does the Line crowded into cutting.
RightWrong
11
