Craftsman 39535006 specifications Youll Need Tools, Features Of Your Opener, Specifications

FEATURES OF YOUR OPENER

1o Opener Lights: Turn on and off automatically, with 4-1/2 minute illumination for your safety and

convenience. Provide constant light when Work Light control button is pressed..

2,. Safety System: Independent up and down force

adjustment.. Door reverses automatically when ob - structed in DOWN direction Door STOPS when

obstructed	in UP dkection
3o Emergency	Disconnect:	Putl cord disconnect

permits manual door operation.

4o Automatic Reconnect: Trolley halves reconnect for automatic operation when opener is energized after emergency disconnect.

5_ Motor Power: 1/2 horsepower permanently lubri- cated motor with automatic reset

6., Digital Radio Controls: 19,683 codes from which to choose Can be changed easily by the owner..

7o Easy Limit Adjustment: Limits of door opening and closing adjusted by turning screws without re-

moving chassis cover:.

8, Vacation Push Button: When the Vacation Push

Button is ON, the openerwill not operate from the transmitter. The door will operate in the UP direc- tion ONLY from the Wall Control (or optional Key Switch accessory, Page 5)

SPECIFICATIONS

Type .

Speed

Volts ._

Current

Gear reduction Drive

Lubrication

Length of Travet Travel rate Lamp

Door linkage

MOTOR

1/2 horsepower permanent split capacitor t500 rpm

120 Volts AC - 60 Hz Only

4 5 amperes

DRIVE MECHANISM

16:1

Chain & cable with two-piece trolley on steel Tee rail

Motor is setfqubricated. Drive shaft bronze off-life bearings

Adjustable to 7-1/2 feet

6 to 8 inches per second

On when door starts in travel, off 4-1/2 minutes after stop, Also separate Work Light push button

Adjustable door arm PuIi cord trofley release

Personal

Electronic

Electrical

Limit device ....

Limit adjustment

Start circuit

Length (overall) . . Headroom required Shipping Weight

SAFETY

Push button & automalic reversal in down

direction. Push button & automatic stop in up direction

Independent up & down force adjustment screws

Motor overload protector and low voltage push button wiring

Circuit actuated by limit nut

Screwdriver adjustrnenl on side panel Low voltage push button or radio controI

DIMENSIONS

122-t/2 inches

2inches

43 pounds

YOU'LL NEED TOOLS

During assembly and installation of your opener, the instruction will call for use of various hand tools. Have a stepladder handy, and those tools illustrated below: Hammer, electric drill (also 3/16" and 5/16" drill bits), screw driver, adjustable end wrench or socket wrench kit, wire cutters, tape measure, pliers and hack saw.

		Pliers	Hack Saw
Tape	Measure
		Wire	Cutters
			Claw Hammer
			Screwdriver
Stepladder			Adjustable End Wrench
Electric	Drili	Socket Wrench