Craftsman 39535006 specifications Assemb, S=E P 2 Connect Trolley & Attach Chain Retainer Bracket

Assemb v

S=_E P 2 Connect Trolley & Attach Chain Retainer Bracket

As a temporary stop, insert a screwdriver into Tee rail as shown. Slide the inner trolley onto the Tee rail, as shown, until it is firmly against the screw- driver, Slide the outer trolley onto the Tee rail until it partially engages the inner trolley and stops

TO FULLY ENGAGE TROLLEY: With a hammer, firmly tap the back end of outer trolley just below the

rail guide. Outer trolley must move forward to fully engage inner trolley., Be careful to avoid damaging trolley spring,

					Outer
					Nut
	Lock	Washer		_5/17",,,	6"
Temporary Stop	inNnur_	5/16"	_..	'	, Chain
Screwdriver		X ).
					Retainer
Cable					Bracket
Pulley		Tl_readed
Bracket
		End

Trolley Attach inner nut, lock washer, chain retainer bracket Shaft

and outer nut to trolley shaft in the order shown The

Fiat Endretainer bracket should be kept in the illustrated position DO NOT TIGHTEN NUTS UNTIL STEP 5, PAGE 9

@USE ON LY THOSE SCREWS MOUNTED IN TOP OF OPENER CHASSlS. FAILURE TO DO SO WILL CAUSE SERIOUS DAM- AGE TO THE DOOR OPENER,

PROCEDURE: Place opener chassis on packing material to protect cover,, For convenience, place a support under the cable pulley bracket,

Remove 5/16"-18xt/2" washered screws mounted in top of opener chassis, Align holes in back end of Tee rail with holes in opener chassis, Fasten the rail to the chassis with washered screws previously

rein eyed. CA UTION: USE ONL Y THESE SCREW St

Use of any other screws will cause serious dam-
age to door opener. Tighten screws securely
Insert a 5/t 6"-18xt/2"	washered screw into the per _

manent	stop	hole in the	Tee	rail back section as	Tee Rail
shown..	Tighten	securely	with	a 5/16" nut.
					(Back Section)

Nut

5/16"-18