Craftsman 39535006 0nstatUation, Caution Be Sure Unit Is Grounded According To Local Code

0nstatUation

STEP 8 ConnectElectricPower

I

TO AVOID SERIOUS PERSONAL INJURY FROM ENTANGLEMENT, REMOVE ALL ROPES CON NECTEDTO THE I GARAGE DOOR BEFORE OPERATING DOOR OPENER_

REMOVE EXISTING GARAGE DOOR LOCKS OR USE A WOOD SCREW OR NAIL TO MAKE THE_,_ INOPERATIVE, INSTALLATION AND WIRING MUST BE IN COMPLIANCE WITH LOCAL BUILDING AND ELECTRICAL CODES. OPERATION AT OTHER THAN !2OV 6OHz WILL CAUSE OPENER MALFUNCTION AND DAMAGE,

IF LOCAL ELECTRICAL CODES DO NOT REQUI RE PER MAN ENT WIRING: Insert the 3-prong plug into a

3-hole receptacle. UNIT MUST BE GROUNDED DO NOT USE A 2-WIRE ADAPTER,

IF LOCAL CODES REQUIRE PERMANENTWIRING: Refer to illustration,

PROCEDURE: Make connection through 7/8 inch diameter hole in top of opener chassis,

1o Remove opener chassis cover by removing the 4 cover screws,

2,, Remove attached 3-prong cord,

3.Connect black (line) wire to black wire on terminal block; white (neutral) wire to white terminal wire; green (ground) wire to green ground screw

CAUTION: BE SURE UNIT IS GROUNDED

ACCORDING TO LOCAL CODE

Ground Tab

Ground Screw

I Wire

_,White Wire

STEP 9 i. to, Lights andLenses

PROCEDURE: Install a 75 watt maximum light bulb in each socket as shown The lights turn on automatF calty when opener starts. After 4-I/2 minutes they will turn off, Lights will REMAIN ON when Work Light push button on Wail Control is pressed,

IMPORTANT NOTE: If the lights in your garage door opener do not work, it may NOT be the fault of

the opener° Some short-neck butbs_ because of their shape, do not make contact with the socket

base tab. Use standard.neck bulbs°

Lens Tab

INSTALLING LENSES: Slide lenses into the fens guides as shown. Snap bottom tabs into lens slots. (The force and limit adjustment settings are located on side panels behind lenses),

NOTE: FOR CONVENIENCE, LENSES MAY BE IN-

STALLED AFTER ADJUSTMENT, STEP 3, PAGE 20_

Lens Slot

Lens Guide

15