Radio Controls
RECEIVER
Code
Switch
Block
RADIO CONTROLS consist of a transmitter and a
receiver° The transmitter sends a coded signal from outside the garage. The receiver is fastened to the
right side panel of the door opener It receives the transmitted signal and starts the door opener.
The signal code is set at the factory Page 23 des- cribes code changing procedures, if required..
Self service of radio controls is not recommended, if service is needed, contact your nearest Sears Ser- vice Center.
| / |
Right Side | Anger |
Panel |
|
THE TRANSMITTER
The portable transmitter may be secured toa car sun visor with the clip provided Additional transmitters can be purchased at any time for use in all vehicles using the garage (Refer to Accessories, Page 5). New transmitters must be set to the same code as
original transmitter and receiver Follow code set- ting procedures described on Page 23
A
THE BATTERY
The battery should produce adequate power for
approximately one year:, Avoid the inconvenience of unexpected battery failure by replacing it annually, preferably before winter.. Alkaline batteries are the most reliable and are available at Sears..
TO REPLACE BATTERY: Remove visor clip and un- fasten connecting screw, Remove top of transmitter case and discard old battery., Snap connector onto new battery, Replace top of case and connectiqg screw. Replace visor clip
TRANSr_tITTER
Battery Test
Light
Push BuUon
Battery
Visor
22