Ass÷mbUv
g_g P 5Tighten the Chain and Cable
OAUTIONt Keep chain from twisting as nuts are turned,
LoosenTighten
InnerOuter
NutNut
O | Lock | Chain |
| Washer | Retainer |
|
| Bracket |
Trolley
Chain
1/2 Inch
i
Base of Tee Rail
STEP (_ Attach Sprocket
Sprocket
Cover
PROCEDURE: Connect chain and cable to threaded
shaft of trolley in the order illustrated: inner nut, lock- washer, chain retainer bracket and outer nut
Tighten the chain and cable by threading outer nut toward trolley,
Chain is properly tightened when it is approximately 1/2" above the base of Tee rail midway between
cable pulley bracket and chassis.
When chain tension is correct, turn inner nut toward chain retainer bracket until tight,
Sprocket noise can result if chain is either too loose or too tight.
CAUTION: Do not overtighten chain and cable.
Refer to Page 21.
Cover to Opener Chassis
PROCEDURE: Attach sprocket cover to chassis as shown in Illustrations (A) and (B). insert back tab in chassis slot Then bend cover forward and insert front tab in slot provided on mounting plate,
tl
Mounting
Plate
ASSEMBLY OF YOUR GARAGE DOOR OPENER IS NOW COMPLETE.
CERTAIN INSTALLATION PROCEDURES VARY ACCORDING TO GARAGE DOOR TYPES. WHERE DIFFER-
ENCES OCCUR, BE SURE TO FOLLOW ONLY THOSE INSTRUCTIONS WHICH APPLY TO YOUR DOOR CONSTRUCTION,,
DO NOT WEAR WATCHES, RINGS OR LOOSE CLOTHING WHILE INSTALLING OR SERVICING A DOOR OPENER°
KEEP GARAGE DOOR BALANCED. STICKING OR BINDING DOORS MUST BE REPAIRED. GARAGE DOORS,
DOOR SPRINGS, CABLES, PULLEYS, BRACKETS AND THEIR HARDWARE MAY BE UNDER EXTREME TEN-
SION AND CAN CAUSE SERIOUS PERSONAL INJURY,, DO NOT ATTEMPT ADJUSTMENTS. CALL A GARAGE DOOR SERVICEI_IAN TO MOVE, LOOSEN OR ADJUST DOOR SPRINGS OR HARDWARE,.
9
