Craftsman 536.88626 Tools Required for Assembly, To Remove Snow Thrower From Carton, Shifter

Parts packed separately in carton (not shown full size)

1- Crank Assembly

2- Ignition Keys

(Attached to engine in plastic hag)

1-Snow Chute Assembly

ml II I I

,_ WARNING:safety glassesAlwaysor eyewearshields wmle assembling snow

thrower.

TOOLS REQUIRED FOR

ASSEMBLY

1 - Knife to cut carton

1 - 1/2 inch wrenches

(or adjustable wrenches) 1 - 9/16 inch wrenches

(or adjustable wrenches) 1 - 3/4 inch wrenches

(or adjustable wrenches)

1 - Pliers (to spread cotter pin)

1 - Screwdriver

1 - Measudng tape or ruler

Figure 1 shows the snow thrower in the shipping position.

Figure 2 shows the snow thrower com- pletely assembled.

References to the right or left hand side of the snow thrower are from the view-

point of the operator's position behind the unit.

Auger Drive Lever

	Drive Lever
	Clutch Cable
Shifter	Crank Assembly
Lever
	Chute
	Deflector

Height

Adjust

Skid Figure 2

TO REMOVE SNOW THROWER

FROM CARTON

1.Locate all parts packed separately and remove from the carton.

NOTE: Place fuel stabilizer in a safe

Figure 1 place until needed for storage.

F-001088,/7