TO REPLACE MOWER BLADE DRIVE BELT
Park the tractor on level surface. Engage parking brake.
1.Remove mower drive belt (See "TO
REPLACE MOWER DRIVE BELT" in this section of this manual).
2.Remove mower (See =TO REMOVE
MOWER" in this section of this manual).
3.Remove screws from R.H. mandrel cover and remove cover. Unhook spring from bolt on mower housing.
4.Carefully roll belt off R.H. mandrel pulley.
5.Remove belt from center mandrel
pulley, idler pulley, and L.H. mandrel pulley.
6.Remove any dirt or grass which may have accumulated around mandrels
and entire upper deck surface.
7.Check secondary idler arm and idler to see that they rotate freely.
8.Be sure spring is hocked in secondary idler arm and
9.Install new belt in lower groove of L.H. mandrel pulley, idler pulley, and center mandrel pulley as shown.
10.Roll belt over R.H. mandrel pulley. Make sure belt is in all grooves properly.
11.Reconnect spring to bolt in mower housing and reinstall R,H. mandrel cover.
12.Reinstall mower to tractor (See =TO iNSTALL MOWER" AND DRIVE
BELT" in this section of this manual).
13.Reassemble mower drive belt (See
=TO REPLACE MOWER DRIVE BELT" in this section of this manual).
Mower
LH. Blade Drive Center
Belt
Idler
R.H.
Cover
Idler Arm
Spring
Sway Bar Screw
Bracket
TO ADJUST ATrACHMENT CLUTCH
The electric clutch should provide years of service. The clutch has a
Adjustments should be made by a Sears or other qualified service center.
1.Make sure attachment clutch and ignition switches are in "OFF" position.
2.Adjust the three nylon Iocknuts until space between clutch plate and rotor measures .012' at all three slot
locations cut in the side of brake plata.
NOTE: After installing a new electric clutch, run tractor at full throttle and
engage and disengage electric clutch 10 cycles to wear in clutch plate.
.012"
Locknut
Plate
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the left side of the transaxle.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted.
1.Depress clutch/brake pedal and engage parking brake.
2.Measure distance between brake operating arm and nut =A" on brake rod.
3.If distance is other than
jam nut and tum nut "A" untildistance becomes
23