Craftsman 917.274953 To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse, Engine

Terminal..::;				ex
Access :: _		_	_	Bolt
Door:----'_'fl_ _		_'	][----Positive
i	L_		_L	(Red)
Terminal_	I	_.	_	Cable
Guard	"_	_	"(_egb_ive (Black)

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly,stop running, or prevent itfrom starting.

•Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to

reconnect the headlight wire connec- tor.

Headlight Wire

ENGINE

Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any non-road engine repair establish- ment or individual. Warranty repairs must be performed by an authorized engine manufacturer'sservice outlet.

TO ADJUST THRO'I-rLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If

adjustment is necessary, proceed as follows:

1.With engine not running, move throttle control lever to fast position.

2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.

Idle Fuel Adjusting	Idle speed Adjusting
Needle

Throttle

Control

Cable

Choke

Control

Cable

Stol

Scre_lam I

26