TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is controlled by the forward and reverse drive pedals.
I. Start tractor and release parking brake.
2Slowly depress forward(K) or reverse(L) drive pedal to begin movemenL Ground speed increases the further down the pedal is depressed,,
TO USE CRUISE CONTROL
The cruise control feature can be used for forward travel onlyo
SYSTEM CHARACTERISTICS
The cruise control should only be used while mowing or transporting on relatively smooth, straight surfaces. Other conditions such as trimming at slow speeds may cause the cruise control to disengage. Do not use the cruise control on slopes, rough terrian or while trimmimg or turning.
• With forward drive pedal depressed to desired speed, pull cruise control lever
(J)up and hold while lifting your foot off the pedal, then release the lever.
To disengage the cruise control, depress the brake pedal, tap on forward drive pedal or push the cruise control lever down.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever (A) determines the cutting height.
•Put attachment lift lever in desired cutting height slot.
•Slide pointer tab (T) to desired cutting height as a reminder for nexttime you mow.
The cutting height range is approximately
I" to 4". The heights are measured from the ground to the blade tip with the engine not run- ning. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.
•The average lawn should be cut to ap- proximately
•For best cutting performance, grass over 6" in height should be mowed twice. Make the first cut relatively high; the second to desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck
in proper position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level surface.
1.Adjust mower to desired cutting height (See "TO ADJUST MOWER CUTTING HEIGHT' in this section of manual).
2.With mower in desired height of cut posi- tion, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole. Tighten
securely°
3_ Repeat for all, installing gauge wheel in same adjustment hole.
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting offwhen operating your equipment on rough, rolling terrain or hills.
1.Select desired height of cut with attach_ merit lift lever.
2.Start mower blades by engaging attach- ment clutch control.
!6
